Enter the 5-digit passcode of your choice (any combination except 00000.) After 5 digits are entered, the green LED turns OFF.(To enter a new User Code, repeat these steps.) Programming a passcode The lock will “beep” and the green LED will come on. (To enter a new User Code, repeat these steps.) After 5 digits are entered the green LED turns OFF. The green LED remains ON while you enter the 5-digit user code of your choice. There are two ways to program a user code. If you wish to give someone else temporary access to the safe, you can program a passcode that can later be erased. But if you prefer to use your own code, you can program the safe to open to the 5-digit User Code of your choice. You can always open the safe by entering the 5-digit Factory Code. There are three possible ways to unlock and access the safe-by entering its preset Factory Code, your own User Code or a Passcode. If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. ![]() The lock allows 5 seconds for each key press. A green PROCEED light and a single beep indicate that the keypad “felt” your touch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |